Tesla smart

ID

Name

Description

1

IR in

Connect IR receiver extension cable to this port, then it is able to use IR control even the KV switch is installed in a rack  

2

DC 12V

12V DC power supply

3

RS 232

Connect this port to any control termination, then it is able to select the input sources by sending RS232 commmands

4

USB2.0 port

For USB2.0 devices, for example printers, USB hard disk, barcode scanner, touch pad,etc

5

HDMI output

Connect to HDMI display

6

Keyboard and mouse input

For USB keyboard and mouse input, including wireless keyboard and mouse

7

HDMI input

Connect to HDMI sources

8

USB data

Connect to computer by USB Type A to Type B cable

9

Auto scan time interval settings

[MIN]: Press [MIN] to loop between 0~59 minutes

[SEC]: Press [SEC] to loop between 0~59 seconds

[Set]: After setting minutes and seconds, press button [Set] to enter final scan time interval setting

10

Status LED

Red: Turn off auto scanning mode

Green: Turn on auto scanning mode

11

IR receiver

Receive IR signal

12

LED display

Display current selected input port

13

Keypad

[1~8]: Press these buttons to directly select input 1~8 sources
[Close]: Press this button directly will turn on or turn off the display out

[Scan]: Press this button to start or stop automatically scan between input 1 to input 8. The interval time can be set by buttons [Set], [MIN], [SEC] as described above

14

LAN port

By connecting to the LAN through this port, you can use the terminal device in the same LAN to send TCP/IP commands to control the switching of input port

15

Power switch

Turn on or off power supply